Figuring Out Air

Factors to Consider When Choosing the Best HVAC Services Tampa

A series of steps that have been divided into three parts result to AC installation. Installation of the indoor unit is the first step which has other sub steps to it. There are some dos and don’ts that need to be observed during selection of an unobstructed location on the interior wall to mount the indoor air conditioning unit.

Some of them are avoiding direct sunlight and heat sources, installing the unit at least one meter away from the antenna, connecting lines, power, radio, television, telephones etcetera, the wall should be strong enough to hold the weight of the unit and avoiding locations where oil mist exists or gas may leak.

Securing the mounting plate to the interior wall is the next sub step in which has some series of steps. They include holding the mounting plate against the wall, using a level to make sure the plate is horizontally level, drilling holes into the wall at appropriate spots to affix the plate to the wall and finally inserting plastic anchors into the holes. A three sub step procedure is involved in creation of a hole in the wall to fit the piping. Finding the best spot for the hole to the exterior based on the opening in the mounting bracket, drilling a hole that has a diameter of about eight centimeters through the wall in which the slope should be downward toward the exterior and finally inserting a flexible flange into the hole are the procedures of creating a hole in the wall for piping.

Checking of the electrical connections involves lifting the unit’s front panel, removing the cover and being sure the cable wires are connected to the screw terminals. Pipes are connected using some key steps. Connection of pipes involves a lengthy procedure in which finally the drainage pipe allows water to drain in an appropriate place.

By pressing the unit against the mounting plate results to securing of the indoor unit to the mounting plate. The second step to AC installation after installation of the indoor unit is installation of the outdoor condenser. It involves choosing the best place to the outdoor unit which also involves choosing the outdoor unit location needs away from any hot, trafficked areas and having a considerable space that ensures proper functioning. In order that installation of the outdoor unit is done then leveling and laying of the ground is done using a concrete pad. The concrete pad should be high enough so that the condenser sits above winter levels.

A Simple Plan: Repair

If You Read One Article About Air, Read This One